1. Set the machine for a 3-thread rolled hem or 3-thread flatlock (left needle for wider beads, right needle for smaller beads).

2. Beads up to 5/32” (4 mm) diameter can be used.

3. Adjust stitch length to suit beads and pearls. 

4. Raise the presser foot and snap on “Beading and Sequin foot”.

5. Place strand of beads/sequins in the guide (1) and (2) to the end of the foot.

6. Lower the foot, sew a few stitches to fix it.

7. Place the fabric under the foot and sew.

"8. Note: If the strand of beads is sewn onto the fabric edge, cutting can be activated. If the strand of beads is sewn on with a flatlock,

fold the fabric accordingly and guide about 1.5 mm from the right of the needle, it should penetrate the fabric edge. Cutting can be deactivated if needed."